Magtek USB MagnePrint Swipe Reader with Encryption Manual do Utilizador descarregar pdf (Página 40)

USB MagnePrint Swipe Reader with Encryption

TERMINATION_CHAR PROPERTY (KB)

Property ID: 5

Property Type: Byte

Length: 1 byte

Get Property: Yes

Set Property: Yes

Default Value: 0D (hex) (carriage return)

Description: This property is defined as follows:

mod c c c c c C c

mod 0 – Send c after card data

1 – Send c after each track

c 1-127 – 7 bit ASCII char code

0 – send nothing

This property is stored in non-volatile memory, so it will persist when the unit is

power cycled. When this property is changed, the unit must be reset (see

Command Number 2) or power cycled to have these changes take effect.

SS_TK2_7BITS PROPERTY (KB)

Property ID: 6

Property Type: Byte

Length: 1 byte

Get Property: Yes

Set Property: Yes

Default Value: 40 (hex) ‘@’

Description: This character is sent as the track 2 start sentinel for cards that have track 2

encoded in 7 bits per character format. If the value is 0 no character is sent. If

the value is in the range 1 – 127 then the equivalent ASCII character will be

sent.

This property is stored in non-volatile memory, so it will persist when the unit

is power cycled. When this property is changed, the unit must be reset (see

Command Number 2) or power cycled to have these changes take effect.

1 2 ... 35 36 37 38 39 40 41 42 43 44 45 ... 71 72

Sem comentários

Magtek USB MagnePrint Swipe Reader with Encryption Manual do Utilizador Página 40